Home > Pond Liners > Liner Seaming & Repair >

Deluxe Repair Kit
25' EPDM Professional Seam Kit
See details below
 
List Price: $230.00
Our Price: $45.00
Savings: $185.00

Quantity in Stock:30

Availability: Usually Ships in 24 to 48 Hours
Product Code: 1588
Qty:

Description
 

Deluxe Repair Kit

Includes 8oz Can of Primer, Seam Roller, Chip Brush, (2) 6" x 12" Patch and 12" x 12" Patch.

Our deluxe repair kit has everything you need to patch damage to your liner. These materials will provide a permanent patch for your liner. These patches are durable and water tight. Any homeowner can do it themselves in about 5 minuntes.


Includes:

  • 1/2 pint EPDM Primer / Splice Wash
  • 8oz Can of Primer
  • Seam Roller
  • (2) 6" x 12" Patch
  • 12" x 12"
  • 3" Paint Brush

Seam Repair Instructions


Step 1: Layout the Liner
Layout the sections of liner to be seamed. Overlap ends 6" - 12"


Step 2: Clean the Seam Area
Lift the top liner. Use gasoline and thoroughly clean the seam area


Step 3: Mark the Seam Area
With the top liner down, use a crayon or lightly score with scissors, the seam area on the bottom liner. Raise the top liner in the preparation for priming


Step 4: Prime the Seam Area
Prime both liners. On the bottom liner, prime an area 1/4" above the mark, approximately 6" - 8" wide. Prime a matching area on the top liner


Step 5: Apply 3" Double Stick
Apply 3" of double sided tape to the bottom liner, pressure rolling as you go to eliminate air bubbles or wrinkles


Step 6: Smooth the Seam
With the double stick paper still on, replace the top liner and pressure roll the seam


Step 7: Seal the Seam
Slit the double stick tape at the middle of the run of the seam. Overlap the liners and carefully remove the paper, pulling off the tape from between the liners at a 45 degree angle, one side at a time


Step 8: Apply 6" Single Stick
Prime an area 6" wide spaced evenly over the exposed edge of the seam. Apply 6" tape over primer


Step 9: Roll and Seal Forever
Thoroughly pressure roll the 6" tape and generously apply lap sealant along both edge of the 6" tape


Step 10: Apply 6" Single Stick
Allow the seam to dry thoroughly before contact with water



Share your knowledge of this product. Be the first to write a review »